Ducati Panigale V4 (Aero) Setup

Every change you can make to the Panigale V4 (Aero)’s suspension falls into one of the circuits below. Knowing which adjusters you actually have is the first step — there’s no point chasing a high-speed compression fix on a bike that only offers preload.

The Panigale V4 (Aero) splits damping into separate high- and low-speed circuits, which is the most adjustment you'll find on a production bike — and the easiest to get lost in.

• Low-speed circuits control what the rider does: braking dive, throttle squat, weight transfer. Start here — this is where lap time lives.
• High-speed circuits control what the track does: kerbs, ripples, sharp bumps. Only touch these once low-speed is settled and you can name the bump that's upsetting you.
• Because the circuits interact, change one at a time and re-ride the same reference corner. Two changes at once on this bike tells you nothing.

Whatever the Panigale V4 (Aero) offers, the order of operations is always the same. Start from the OEM clicker baseline (count every adjuster from fully closed), set tyre pressures, then set sag before you touch a single damping clicker.

• Tyre pressure first.It moves the chassis more than any clicker. Start from a known cold target — see the track day tyre pressure guide.
• Then sag. On a superbike / sportbike machine, aim for roughly 30–35 mm of front rider sag and 25–30 mm at the rear, then verify against the manual. Full method in the sag guide.
• Then one clicker at a time. Change one thing, ride the same reference, log it. The full loop is in the suspension tuning guide.

On the Panigale V4 (Aero), as on any bike, diagnose by the corner phase where the problem shows up — not the symptom alone. Ordered by what this bike can actually act on:

• Running Wide — A motorcycle that runs wide on entry is a different problem from one that runs wide on exit. Diagnose by corner phase and find the adjuster that fixes it.
• Braking Chatter — Front-end chatter under heavy braking, diagnosed: tire pressure, sag, compression and rebound — and how to tell setup from a tire or technique problem.
• Setting Sag — Measure and set static and rider sag on a motorcycle — the geometry baseline every other suspension change depends on. Targets, method and mistakes.
• Cold vs Hot Tear — Cold tear and hot tear look similar but mean opposite things. Read motorcycle tire wear patterns and what each says about pressure, temperature and setup.